V-5300 Series Low Differential Vacuum Switch

  • Low Cost
  • Subminiature Size
  • Low Differential
  • Fast Response

V-5300 Series Low Differential Vacuum Switch

Air Logic V-5300 Series Low Differential Vacuum Switch

The V-5300 Series Low Differential Vacuum Switches, designed for a minimal difference between the "ON" and "OFF" vacuum, interface from vacuum to electric control circuits. The switches are adjustable from 1 to 28" Hg with a maximum signal pressure of 29.9" Hg.

The switches have three electrical terminals: Normally Open, Normally Closed, and Common. 4 AMP switches are standard; a 0.1 AMP switch is also available.

Four mounting styles are available: Flush Mount, Manifold Mount, Panel Mount, and Pipe Thread Mount. The Flush Mount has .125" diameter mounting holes for mounting on a flat surface. The Manifold Mount is designed to mount directly on pneumatic circuit boards or manifold subplates; a Buna-N o-ring is supplied. The Panel Mount has a unique thread that goes from 1/8-27 tapered pipe thread to 1/8-27 straight pipe thread; a mounting nut is supplied. The Pipe Thread Mount has 1/8-27 tapered pipe threads.

The switches are provided with a B80 Barb, 10-32 UNF Barbed Fitting, for 1/16" I.D. tubing unless otherwise requested.

Electrical Specifications

Switch Action: Single pole, double throw
Electrical Rating: 4 AMP is standard; no selection number is required. 0.1 AMP is also available.
Electrical Switch: UL Approved, (UL# E12252)
Electrical Connections: .110" quick-connect terminal

Mechanical Specifications

Operating Speed: Activate or release in 25 milliseconds
Signal Pressure: 29.9" Hg maximum
Adjustment Range: 1 to 28" Hg
Temperature Limits: 40 degrees to 120 degrees F (4 degrees to 49 degrees C)

Housing: Polysulfone
Diaphragm: Polyurethane
Spring: Stainless Steel or Music Wire

Port Connections

10-32 female threads, furnished with barbed fitting:

B80: 10-32 UNF Barbed Fitting for 1/16" I.D. tubing
B85: 10-32 UNF Barbed Fitting for 1/8" I.D. tubing
B86: 10-32 UNF Barbed Fitting for .170" I.D. tubing


Flush Mount: .125" diameter mounting hole; use NO. 4 self-tapping or 5-40 screw
Manifold Mount: Two .125" diameter mounting holes; use No. 4 self-tapping or 5-40 screw (A Buna-N o-ring is supplied)
Panel Mount: External 1/8-27 NPT to 1/8-27 NPS, internal threads are 10-32 UNF. A 7/16" diameter mounting hole is required. (A mounting nut is supplied)
Pipe Thread Mount: 1/8-27 male tapered pipe threads with 10-32 UNF female internal threads